Fraud Blocker

SHEDEX FLEURIEU

Shed Care & Maintenance

Look after your shed, and it’ll look after you

Why it matters

Five minutes with a garden hose does more for your shed than you’d think. Rain cleans your roof for you, but it can’t reach under your eaves, behind your gutters or the bottom of your walls. That’s where dirt and salt build up, hold moisture against the steel and shorten its life.

Many property owners don’t realise their BlueScope warranty depends on this regular washing. On the Fleurieu, where salt air travels further than you’d expect, it matters even more.

The good news? It’s mostly just a hose and a bit of routine.

Person hosing down the walls of a dark COLORBOND shed with a garden hose

Your care calendar

First, find your column. Not sure? If you can taste salt on the breeze, use the coastal one.

TaskRural / suburbanNear the coast (within a few km)Beachfront / exposed
Wash walls, eaves and roller door curtain6 months3 monthsMonthly
Check horizontal cladding for dust build-upMonthlyMonthlyMonthly
Clear gutters, check downpipes run clear of the slab6 months6 months3 months
Wipe access door, lock and hinges6 months3 monthsMonthly
Silicone roller door guides, check fasteners for red rust6 months6 months3 months
Roller door service (qualified door technician)2 years2 years2 years
Infographic showing how often to wash a COLORBOND shed: rural every 6 months, near the coast every 3 months, beachfront monthly

Every time you wash

  • Hose the walls, especially under the eaves and anywhere rain doesn’t reach.
  • Wash the roller door curtain inside and out – salt builds up on the inside too.
  • Wipe the access door, lock and hinges.
  • Sweep grit from the door line and the slab edge.
  • Look for red rust on fasteners and swarf stains, and deal with them straight away.

For dirt that won’t hose off, use warm water with a mild dishwashing liquid and a soft cloth or nylon brush. Go gently, then rinse straight away with clean water.

Straight after handover

Give the walls a thorough rinse soon after we finish. This washes off swarf – tiny steel particles from cutting and drilling. Left on the steel, swarf rusts and leaves red-brown stains. Pay extra attention around the vermin flashing.

Close-up of vermin flashing sealing the bottom of COLORBOND wall sheets

What to keep away from your shed

  • Abrasive or solvent-based cleaners – turpentine, petrol, kerosene, paint thinners.
  • Hydrochloric (brick) acid or other strong acids, anywhere near the shed.
  • Soil, mulch, fertiliser and garden beds against the cladding. Leave at least 75 mm between the bottom of the sheets and the soil (50 mm above paving or concrete).
  • Green, wet or treated timber touching the steel.
  • Sunscreen, chemicals and fumes.
  • Graffiti removers and paint strippers. Most void your warranty.

Scratches: leave them alone (mostly)

Genuine COLORBOND® colour is baked on at the factory. Touch-up paint from a can just air-dries, so it ages differently and the patch shows more every year. BlueScope’s advice, and ours: don’t paint over scratches.

Small scratches under 2 mm wide are best left – the coating underneath is still doing its job. Anything bigger on a new shed? Talk to us before it starts to rust.

Roller doors and access doors

Your roller door is the hardest-working part of your shed. Spray a light dry silicone on the guides – no oil or grease, they attract grit. Have it serviced every two years by a qualified door technician, and never adjust the springs yourself.

Doors are covered by their manufacturer’s warranty, not ours, and that warranty depends on this care too.

Gloved hand spraying dry silicone onto a roller door guide

Your slab

  • White powder on the concrete? That’s efflorescence. In the first year it’s normal and stops on its own. Don’t seal or paint the slab until it does.
  • Keeps coming back after a year? Water is getting in from outside. Check downpipes, garden beds, sprinklers and the ground slope, and fix the water first.
  • Orange plastic around the edge? That’s the Fortecon vapour barrier under your slab. Please leave it in place. You can fold it up against the slab and hide it with gravel or paving.
  • Oil spill? Cover it with sawdust or cat litter straight away. Don’t wipe it – that spreads the stain.

Want to know more about what’s under your shed? Read why we pour slabs first and our concrete FAQs.

White powdery efflorescence on the surface of a concrete slab

Keep a record – it’s your warranty evidence

Jot down each wash, check and service in the maintenance log at the back of your Care Guide. If you ever need to make a warranty claim, it’s the first thing BlueScope or a door technician will ask for.

Every ShedEx build also comes with a 3-month defects period plus your statutory warranties under South Australian law.

Have a question about your shed?

We’re happy to help – even if it’s just “is this rust or dirt?” Call (08) 8552 9092 and have your job number handy. Or browse our Shed FAQs.